Dome CXtra Guide de l'utilisateur télécharger pdf (Page 86)

82 | Dome CXtra

Configuring the DICal Service

The desktop display ships with brightness and contrast values already

set (defaulted) for DICOM compliance, as shown in this sample table.

Start at procedure step 2 to configure the DICal service upon initial

use. Use the entire procedure to configure the service after display

settings have been changed.

To configure the DICal service

1 Set the brightness and contrast of your display. (Refer to the display

manual for how to set the values.)

2 Open the CXtra Services menu and select DICal Panel

Configuration.

3 Verify that the model number of your display appears in

the dialog.

If the correct model number is visible, skip to step 5.

If the model number is incorrect, continue to step 4.

4 Click Edit Type, select the model number of the display from

the drop-down list, and click OK.

NOTE: Displays listed have been characterized; therefore, the

Characterize button is disabled. You cannot recharacterize a display

that has been characterized previously.

5 Open the Calibration tab and select DICOM response function.

6 Click OK.

Display Model Brightness Contrast

GX24 77%-83% 80%

GX2MP 75% 75%

GX2MP (JUN 2007 and later) 75% 70%

GX2MP (JAN 2010 and later) 65% 70%

GX2MP (FEB 2011 and later) 65% 70%

GX2MP (SEPT 2011 and later) 65% 70%

GX2MP Plus

(NOV 2011 and later)

* This entry shows the percentages of brightness and contrast with Backlight

Stabilization (BLS) off. When on, the BLS sensor maintains brightness at 185 cd/m

65% 70%

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 167 168

Pas de commentaire

Dome CXtra Guide de l'utilisateur Page 86